A- Frequency (direct input): 32.768 kHz or 12.288 MHz.(Supported only when system clock is 32.768 kHz.) Q6 Output voice data is cut on streaming playback.(Host interfacebmode:SPI).Q5 Once stop the voice output by ISC_SEQUENCER_STOP_REQ command, there is a case voice data is NOT out.Q3 It takes some time to change volume after sending volume change command.Q3 SPI-Flash written by ROM writer can be used?.Q8 It is NOT neccesarry a final streaming is 512/1024/2048byte?.Q7 Volume setting can be changed on stream playing?.Q6 What data should be sent on streaming mode?.Q5 Message protocol manual does not reccommend sequence playback on I2C mode, any issue?.Q3 S1V3G340 has volume setting function?.Q5 Possible to stream voice data from Host CPU on UART mode?.Q3 What output data from voice data creation tool should be written on SPI-Flash.Q1 SPI-Flash data can be updated through S1V3G340 from Host CPU?.Q7 Anything need to prepare to use the evaluation board?.Q6 The evaluation board can be used as mass production?.Q5 The evaluation board can connect with extrenal amp?.Q4 The evaluation board can connect with HOST CPU board?.Q2 What is the fist step after getting evaluation board?.Q16 The delay between phrases in sequencer function is possible?.Q12 If not use SPI-Flash, how to set pins for SPI-Flash?.Q8 How many minutes voice can be put on SPI-Flash?.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |